The common faults and maintenance measures of 400w electrical chain saw are as follows:

1, the battery can not be charged normally, there may be a battery and charger do not match, or there is a voltage problem, first of all to confirm that the charger is matched with the product, and pay attention to the charging voltage and the nameplate voltage is consistent, if there is a problem, should immediately replace the charger or adjust the voltage.

2, if you accidentally insert a piece of not cut into the incision, then it will be stuck, can not be used.

3, if the branches are cut too fast, the above situation will occur, turn off the leaves, that is, loosen the board.

4. During use, if the battery does not operate according to the instructions, the power should be turned off immediately to avoid contact with any liquid. If accidentally contaminated with liquid, should immediately rinse with water.

400w electrical chain saw Expansion data:

400w electrical chain saw Although it is very convenient to use, if you do not carry out daily maintenance and maintenance, it is easy to cause damage and even shorten the service life. The maintenance method of 400w electrical chain saw is:

1, before each charge, cut off the power supply and press about 50 times to make it work for about 5 minutes.

2. After using 400w electrical chain saw, please be sure to wipe the blade and fuselage clean with alcohol to remove debris such as wood chips.

3, long-term use of 400w electrical chain saw, please be sure to pay attention to the maintenance of the battery, to ensure that every month to charge, so as not to greatly shorten the battery life.

4, 400w electrical chain saw and battery stored in a cool place, not more than 30℃.

5, 400w electrical chain saw battery should not be placed for a long time, otherwise it will make the battery soft, and the outflow of harmful materials, therefore, when not in use, please store it separately.

The voltage of the lithium battery is normal, but after driving for a period of time, it will turn off the power and then restart, such a cycle is unstable.

1, the battery can not be charged normally, there may be a battery and charger do not match, or there is a voltage problem, first of all to confirm that the charger is matched with the product, and pay attention to the charging voltage and the nameplate voltage is consistent, if there is a problem, should immediately replace the charger or adjust the voltage.

2, if you accidentally insert a piece of not cut into the incision, then it will be stuck, can not be used.

3, if the branches are cut too fast, the above situation will occur, turn off the leaves, that is, loosen the board.

4, in the process of use, if the battery does not operate according to the instructions, the power should be turned off immediately to avoid contact with any liquid. If accidentally contaminated with liquid, should immediately rinse with water.

400w electrical chain saw https://www.keylead.cn/Electrical-Chain-Saw-Supply.html